Your Spouti™ has arrived

Now it's time to get down to business!

Finding your urethra isn’t intuitive, so we’ve pulled together our experiences from the last two years to help get you peeing like a pro. This is a part two of a series so stay tuned!

A reminder from our previous post: Successful Spouti™ Placement – Achieve the Perfect Seal Pt. 1

  • Make sure you are completely dry before placement

  • Make sure you are standing with your legs together

  • Make sure the Spouti™ tab is resting underneath the clitoris

 

You’ve done it. You found your urethra, you’ve gotten Spouti™ centered, you were certain this was it – but you still sprung a leak.

You might be muttering “What the heck is going on??”  So you reach out to the good folks at My Spouti, LLC and we ask you a few questions.

Today we’ll discuss one of the most common questions:

Do you have a bit too much junk in the trunk?

 

Spouti™ was meant to rest below the clitoris. (See the note above? ^^) If you notice that the tab is resting on top of your bits and not below them, then you’ll need to make a very simple modification. “How come?” Glad you asked!

 

We worked diligently during manufacturing to ensure that Spouti™ was flexible enough so to comfortably wear while sitting. The original plan was to take a big chunk out of the tab to make this happen. We quickly realized that doing so would make Spouti™ look like a pair of needle nose pliers. Let’s be honest – no one wants to put something that looks like pliers down by the sensitive bits!

 

So we went with the triangle shaped cutout to achieve that comfortable flex. However, because everyone is molded differently this means that some people are going to need a smaller tab.  Taking a small pair of scissors to the tip of the triangle opens that tab right up and gives you the room you need to wear Spouti™ without mushing your bits!

 

“So…. How do I make this modification exactly?” Don’t worry it’s super easy to do – just take a pair of scissors to the tip of the triangle and snip that tip so it looks like this:

This is the before you snip the tip!
This opens the tab to give you more room!

Once you get that little modification out of the way give your Spouti™ a quick wash and go ahead and try out your placement. You should see a dramatic improvement in comfort and seal!

 

As always – if you have any questions, or need any advice, reach out to us through our email or any of our social media platforms. We have over 2 years of experience placing Spouti™ models and it is our pleasure to use our expertise to ensure that you have the best, and leak free, STP experience possible!

To be continued….

My Spouti. LLC

My Spouti. LLC

Spouti™ measures at 3cm long, is roughly half an ounce in weight, and is made with soft, biocompatible, FDA approved silicone. Spouti™ uses fluid dynamics to eliminate backflow, allowing the user to void on-demand and remain completely dry. Our form-fitting design is completely comfortable for continuous and prolonged wear. The support of the labia and the pressure of the thighs keeps Spouti™ in place, the application of silicone tape can create a stronger hold for users as needed. While the main application for Spouti™ is to allow female users to void while standing - typically in a backpacking type environment, several of our current users wear Spouti™ from their wheelchairs. Placement requires the user to locate their urethra and center it beneath the cup. This typically takes 20-30 seconds once the user has become familiar with placement. Spouti™ is simple to clean. After removal and/or before placement, simply wash with antibacterial soap and warm water. Spouti™ can also be boiled if desired.

FTM_London/Spouti™ Giveaway!Win a Free Spouti™